HOBBYWING R/C 101 - Understanding R/C

Everyone starts from something new.  Let's list the basics in R/C terms.  If there is any topic/subject you think we should add, please leave a message below. 

 

Well, we will start from very basics...

BATTERY: 

Battery University's web site (one of the best educational battery sites out there)
http://batteryuniversity.com/learn/

3.7 volt battery = 1 cell x 3.7 volts (1S)
7.4 volt battery = 2 cells x 3.7 volts (2S)
11.1 volt battery = 3 cells x 3.7 volts (3S)
14.8 volt battery = 4 cells x 3.7 volts (4S)
18.5 volt battery = 5 cells x 3.7 volts (5S)
22.2 volt battery = 6 cells x 3.7 volts (6S)
29.6 volt battery = 8 cells x 3.7 volts (8S)
37.0 volt battery = 10 cells x 3.7 volts (10S)
44.4 volt battery = 12 cells x 3.7 volts (12S)

What is R/C Lipo battery?  

http://www.rchelicopterfun.com/rc-lipo-batteries.html

Battery & Balance Connector type

http://www.falconsekido.com/blogs/news/14906981-rc-101-battery-balance-connector-type

 

Pinion Gears / FDR:

 http://www.falconsekido.com/blogs/news/14868017-r-c-101-pinion-gears-fdr

What is drag brake?

ESC's use a PWM (pulse width modulation) scheme for both acceleration an braking. In acceleration, the power to the motor is switched on and off at a very high rate. The ratio of power on time to power off time controls motor speed. The more of the time the power is on, the faster the motor goes.

Similarly, in braking the electrical short across the motor is switched on and off at a very high rate. The ratio of short applied time to short disconnected time controls braking power. The more of the time the short is applied the more powerful the braking.

The drag brake setting is simply the amount of braking power applied at off-throttle.

If you could instantly move your trigger finger from acceleration to a consistent braking position (value) when you wanted to perform a stop maneuver, you would be accomplishing the as the drag brake setting.

What is Transistor, diode, capacitor?? 

http://www.popularmechanics.com/technology/how-to/tips/the-10-things-youll-need-to-build-your-very-first-robot#slide-1

 

Blew up capacitor?

The small spark is NOT possible to damage the capacitor or the ESC. If capacitor smokes or becomes balloon, there are 2 reasons:
  • The battery polarity is wrong (This is the most possible reason)
  • When soldering the capacitor module to the ESC, the positive pole (+) of capacitor should be soldered to the + pole of the ESC, and negative pole (-) of capacitor should be soldered to the negative pole of the ESC. If they were swapped, the capacitor would be damaged immediately. 
The capacitor is important component for an ESC. It filters the RF interference to make the ESC work reliably, so please don't use an ESC without capacitor (or capacitor module).

 

Cart Summary

Your cart is empty

HOBBYWING Lifestyle gears

  • HOBBYWING Cap - Urban Hunter Limited Edition
    HOBBYWING Cap - Urban Hunter Limited Edition HOBBYWING Cap - Urban Hunter Limited Edition
  • HOBBYWING HOODIE- Nerd The New cool edition
    HOBBYWING HOODIE- Nerd The New cool edition HOBBYWING HOODIE- Nerd The New cool edition
  • HOBBYWING shirts - Nerd The New Cool edition
    HOBBYWING shirts - Nerd The New Cool edition HOBBYWING shirts - Nerd The New Cool edition
  • HOBBYWING Cap - BEANIE KNIT Limited
    HOBBYWING Cap - BEANIE KNIT Limited HOBBYWING Cap - BEANIE KNIT Limited
  • HOBBYWING Pit Mat
    HOBBYWING Pit Mat HOBBYWING Pit Mat
  • Raceway and Shop HOBBYWING Banners
    Raceway and Shop HOBBYWING Banners Raceway and Shop HOBBYWING Banners

From the Blog

Ultimate RC - Mars Ingenuity

Ultimate RC - Mars Ingenuity

febrero 24, 2021

Our hobby activities do not stay here. If you can work as hobby, what else you need?   Work does not...

Read more →

About Us

HOBBYWING North America (HWNA) is established with a clear mission in mind. "Help create memorable moments worldwide". We are privately held and fe...

Read more →